LoRad Cord Sets

LoRad Cord Sets

LoRad CS-EU (10A)
EU-version, with Schuko plugs, is the most common standard throughout Europe. Exceptions are Denmark, Italy, Ireland and Britain.

LoRad 1.5 CS-EU
Screened cord set with LoRad 3x1.5 mm² cable, SWF10 female connector (IEC-320) and SW-EU male plug.
Current rating 10A

LoRad 2.5 CS-EU
A similar cord set but with LoRad 3x2.5 mm² cable.
Current rating 10A.

LoRad CS-EU (16A)

LoRad 2.5 CS-EU-16
Screened cord set with LoRad 3x2.5 mm2, SWF16 female connector (IEC-320) and SW-EU-16 male plug.
Current rating 16A.

LoRad BS Cord Sets
LoRad CS-BS British standard, BS1363A. This BS-approved cord set is available only in CSA 3x1.5 mm² . British (UK) safety standard does not approve factory produced cord sets of CSA 2.5 mm².

LoRad 1.5 CS-BS
Shielded mains cord set with LoRad 3x1.5 mm2, SWF10 female connector (IEC-320) and MC-BS male plug.

LoRad CS-US
US-version, Nema-15, is the American standard and also common throughout Asia. The plug is approved Hospital Grade.

LoRad 1.5 CS-US
Screened cord set with LoRad 3x1.5 . mm2,SWF10 female connector (IEC-320) and SW-US male plug.
Current rating 15A.

LoRad 2.5 CS-US
Screened cord set with LoRad 3x2.5 mm2, SWF10 female connector (IEC-320) and SW-US male plug.
Current rating 15A.

The Lorad Concept
LoRad is a mains flex with patented screening for connection of audio equipment to 230V mains. The screening minimizes the interference from electric alternating fields, protecting from both radiation and pick-up. For cancelling of magnetic alternating fields the LoRad is cabled with a short pitch twisting. LoRad, the only approved screened mains flex. Owing to the patented design the drain wire is eliminated and instead the screen is automatically connected to earth via a green semi-conductive plastic on the earth conductor. This enables the cable to pass the flex test of 2x30,000 bending strokes without damage, for safety approval, whereas a drain wire would cut through the insulations during the test. The LoRad is very flexible owing to the multiwire conductors. Each conductor is made of 320 tin plated copper wires.

LoRad stands for Low Radiation of electric and magnetic alternating fields
The screen protects your equipment from radiated mains noise and from RF oick-up.
Short pitch twisting of the cores cancels the magnetic alternating fields.
This will result in a cleaner sound and more accurate transients.

The screen is ground connected via a semi-conductive PE on the earth conductor. No drain wire needed. The green part of the yellow/green earth conductor is of two different green nuances. Please be aware that the darker green plastic is the semi-conductive part. It must not touch any live part of the cord set.

<<< Cord Sets, Technical Specifications >>>

Go Top